Building a Model Handle
IntroOne of my constant worries has been how to handle a model when I am painting it without touching areas already painted.
After trying different methods, I have finally found an easy and convenient way using magnets.
- A couple of strong magnets with a hole. You can get them on ebay quite cheap, just look for Neodymium N50 (or higher) grade.
The bigger, the better. Mine are 10*20*5 mm and are strong enough to hold safely a T-34 at 1/35 with its turret (no metal tracks though) .
- A file handle, available at hardware stores. A simple stick can work as well if you can not get the handle.
- A screw!
ProcedureNot too much to say here. Screw the magnet to the handle. Then put the other magnet inside the model and stick them together.
In case of closed vehicles you will have to glue it to the hull bottom and leave it there forever.
While you are not using it, you can either remove the handle or place it inside a jar as shown.
A note of warning. These magnets are really strong, specially the bigger ones so DO TAKE CARE WITH YOUR FINGERS. They can jump considerable distances to stick together.
I hope you find it useful.
Copyright ©2020 by Carlos Martin. _OPINIONS RailRoad Modeling, KitMaker Network, or Silver Star Enterrpises. Images also by copyright holder unless otherwise noted. Opinions expressed are those of the author(s) and not necessarily those of ModelGeek. All rights reserved. Originally published on: 2015-09-02 08:43:47. Unique Reads: 20723